Avery sheet
1" round · symbol sticker or tube cap
1" diameter cannabis label die-line, measured to the trim with 0.0625" bleed. 63 per Letter sheet, fits Avery 94066.
Measurements
| Trim size | 1" diameter |
|---|---|
| Shape | Round |
| Bleed | 0.0625" beyond the trim on every edge |
| Goes on | pop-top containers and small tubes |
| Per Letter sheet | 63 — 7 across by 9 down |
| First label at | 0.375" from the left, 0.5" from the top |
| Label pitch | 1.125" across, 1.125" down |
| Avery blanks | 94066 |
| Measured from | Avery 94066 spec: 63 per sheet, margins 0.5 top/bottom and 0.375 left/right; 7×9 at 1.125 pitch is the only grid that fits. Matches OnlineLabels OL5375 |
Not a print-to-the-edge sheet: keep the bleed white or use 94500.
Designing for this label
Artwork is drawn at this shape rather than resized into it. A round lid is not a square design cropped, and a bag face is not a jar label scaled up: the composition has to be built for the proportion it will be printed at, or the name ends up cut in half at the trim.
The export places the artwork inside this die-line with the bleed above already allowed for, so the PDF is ready for an ordinary inkjet or laser printer with nothing to line up by hand.
Printing it
The export lays 63 labels out on a Letter page at the exact pitch above, so a sheet of blanks feeds straight through an ordinary inkjet or laser printer. Print at 100% with page scaling off — "fit to page" shrinks the artwork by a few percent and every label on the sheet drifts off its die-line. Print the free calibration sheet on plain paper first and hold it against a sheet of blanks to check your printer's own margins before committing a real sheet.
Download the calibration sheet for this layout — free, no account, one sheet of plain paper.
Make one for this shape
Nothing in the catalog is drawn for this one yet. Describe what you want and the builder will draw it at this shape, then lay it out on the sheet as a print-ready PDF.