Avery sheet
2.625" × 1" address label · pre-roll tube or info strip
2.625" × 1" cannabis label die-line, measured to the trim with 0.0625" bleed. 30 per Letter sheet, fits Avery 5160, 8160, 5960, 8460, 18660.
Measurements
| Trim size | 2.625" × 1" |
|---|---|
| Shape | Rectangle |
| Bleed | 0.0625" beyond the trim on every edge |
| Goes on | pre-roll tubes and jar wraps |
| Per Letter sheet | 30 — 3 across by 10 down |
| First label at | 0.1875" from the left, 0.5" from the top |
| Label pitch | 2.75" across, 1" down |
| Avery blanks | 5160 · 8160 · 5960 · 8460 · 18660 |
| Measured from | measured from the Avery 5160 template PDF: label left edges at 0.1875 / 2.9375 / 5.6875 and row boundaries every 1.0 from 0.5, giving 0.5 top and bottom margins and 0.1875 each side |
The widest face here at 2.625:1. Generated at 3:2 and center-cropped, so roughly a third of the image height is discarded — keep the subject centred and do not put anything near the top or bottom edge. Rows butt vertically with no gap, and this is an address-label sheet rather than a print-to-the-edge one, so keep artwork off the trim.
Designing for this label
Artwork is drawn at this shape rather than resized into it. A rectangle is not a square design cropped, and a bag face is not a jar label scaled up: the composition has to be built for the proportion it will be printed at, or the name ends up cut in half at the trim.
2.625" × 1" address label wraps a tube and loses the top and bottom of the image to the crop, leaving only a small window in the centre, so these layouts are the ones that hold on it:
- Minimal mark
- Mascot emblem
- Crest
- Brand first
- Stacked tower
The export places the artwork inside this die-line with the bleed above already allowed for, so the PDF is ready for an ordinary inkjet or laser printer with nothing to line up by hand.
Printing it
The export lays 30 labels out on a Letter page at the exact pitch above, so a sheet of blanks feeds straight through an ordinary inkjet or laser printer. Print at 100% with page scaling off — "fit to page" shrinks the artwork by a few percent and every label on the sheet drifts off its die-line. Print the free calibration sheet on plain paper first and hold it against a sheet of blanks to check your printer's own margins before committing a real sheet.
Download the calibration sheet for this layout — free, no account, one sheet of plain paper.
Make one for this shape
Nothing in the catalog is drawn for this one yet. Describe what you want and the builder will draw it at this shape, then lay it out on the sheet as a print-ready PDF.