Avery sheet
54 mm round · 3.5 g tin lid
54 mm round cannabis label die-line, measured to the trim with 0.0625" bleed. 12 per Letter sheet of full-sheet stock, cut by hand.
Measurements
| Trim size | 2.126" diameter |
|---|---|
| Shape | Round |
| Bleed | 0.0625" beyond the trim on every edge |
| Goes on | 3.5 g press-in tins |
| Per Letter sheet | 12 — 3 across by 4 down |
| First label at | 0.937" from the left, 1.062" from the top |
| Label pitch | 2.25" across, 2.25" down |
| Measured from | 54 mm is the top-label size sold for 3.5 g press-in tins; 2.126" is that converted at 25.4 mm/in. The 3x4 grid is our own imposition on full-sheet stock — a fourth column needs 8.504" of an 8.5" sheet and a fifth row leaves a 0.185" top margin, inside what most printers refuse to print |
Full-sheet label, cut by hand. The 0.124" gap between labels is there to give a blade somewhere to go. Tins vary by a millimetre or two between sellers — measure yours against the first sheet before printing twelve.
Designing for this label
Artwork is drawn at this shape rather than resized into it. A round lid is not a square design cropped, and a bag face is not a jar label scaled up: the composition has to be built for the proportion it will be printed at, or the name ends up cut in half at the trim.
54 mm round is a small disc read from any angle, so these layouts are the ones that hold on it:
- Roundel
- Full bleed
- Mascot emblem
- Crest
- Minimal mark
The export places the artwork inside this die-line with the bleed above already allowed for, so the PDF is ready for an ordinary inkjet or laser printer with nothing to line up by hand.
Printing it
The export lays 12 labels out on a Letter page at the exact pitch above, so a sheet of blanks feeds straight through an ordinary inkjet or laser printer. Print at 100% with page scaling off — "fit to page" shrinks the artwork by a few percent and every label on the sheet drifts off its die-line. Print the free calibration sheet on plain paper first and hold it against a sheet of blanks to check your printer's own margins before committing a real sheet.
Download the calibration sheet for this layout — free, no account, one sheet of plain paper.
Make one for this shape
Nothing in the catalog is drawn for this one yet. Describe what you want and the builder will draw it at this shape, then lay it out on the sheet as a print-ready PDF.